If metal shims are used for alignment adjustment in the front, they adjust ________

A) Camber B) Caster C) Toe D) Both A and B


D

Trades & Technology

You might also like to view...

Answer the following statement(s) true (T) or false (F)

1. When two or three single-phase transformers are used to transform voltages on a three-phase system, they are known as a transformer connection. 2. In general, the low-voltage winding leads are not marked. 3. The wye–wye connection cannot be used in those applications where the load on the secondary side is balanced. 4. Determining whether a problem with harmonics exists in a three-phase system is similar to determining the problem in a single-phase system. 5. It is generally not practical to remove the equipment causing the harmonic distortion, so other methods must be employed.

Trades & Technology

Some antilock braking systems use a yaw sensor. Where is this sensor usually mounted?

A) In the front of the vehicle near the radiator B) Inside the vehicle under a seat C) Attached to or near the brake pedal assembly D) On the master cylinder

Trades & Technology

Individual small scale turbines can, under the right conditions, generate between ____ kWh, depending on local wind speed, turbine size, and tower height.

A. 150 and 1500 B. 300 and 2000 C. 400 and 2500 D. 450 and 3000

Trades & Technology

The process in which heat is applied to remove strains and reduce grain size is known as _____

A) tempering B) annealing C) normalizing D) stress relieving

Trades & Technology