The U-joint cap angle was measured to be 14.5 degrees. After rotating the driveshaft 90 degrees the angle of the yoke was measured to be 10 degrees. The working angle of the driveshaft is ________
A) Too large B) OK
C) Too small D) Not enough information to answer the question
A
You might also like to view...
The strength of sheet steel used for making EQ studs is
A) 50 ksi. B) 33 ksi. C) 40 ksi. D) greater than 50 ksi. E) less than 33 ksi.
As leisure time for the American public increases, discuss how this affects the demand for activities in fish and wildlife
What will be an ideal response?
List three shop tests that can be applied to determine what type of steel is in a particular part
A) Spectrometer analysis B) Scratch, file, spark, magnet and machinability C) Comparative weight of samples D) Microscopic grain etching
Si observa una condición peligrosa en una obra, debe:
a. simplemente evitarla. b. contárselo a un compañero de trabajo. c. informarla a un supervisor. d. llamar a OSHA.