When installing a gauge hose on a R-134a system the gauge will only read system pressure once:
A. The spring loaded collar has been pulled back
B. The coupler has been installed and the hand valve has been back seated
C. The coupler has been installed and hand valve had been front seated
D. The protective valve cap has been removed
Answer: C
You might also like to view...
Describe the properties and uses of resorcinol resin adhesives.
What will be an ideal response?
What information is available on electrical one-line diagrams?
What will be an ideal response?
Split-system heat pumps have a third service valve that is not connected to either refrigerant line. This extra valve:
A) Is used to read the defrost pressures during the defrost cycle. B) Is only needed during the cooling cycle. C) Is always connected to the low side of the system regardless of the operating cycle. D) Is a backup in case one of the other service valves quits functioning.
When a part is touching primary and secondary datum planes and comes in contact with a tertiary plane, it theoretically touches the tertiary plane in ____.
A. four or more points B. three points C. two points D. one point