For a 700 mm cut with a feed of 0.25 mm and an rpm of 600, what is the cutting time in minutes? Use T = L/FN.  Round to one decimal place.

A. 4.9
B. 4.7
C. 6.3
D. 7.0


Answer: B

Trades & Technology

You might also like to view...

In surface _____, coarse sand particles that are too large to be kicked into the air by wind can roll

along the ground under the impact of saltating sand grains.

Fill in the blank(s) with the appropriate word(s).

Trades & Technology

The service disconnecting means for a one-family dwelling load calculation must have a rating of at least ____.

A. the calculated load B. the load for a single unit C. one quarter the total load D. one half the total load

Trades & Technology

What law says employers must provide information about hazardous materials used in the work place?

A) OSHA B) RCRA C) EPA D) Right to know

Trades & Technology

Organic fruit production:

A. is impractical so organic fruit is not grown. B. can be described as benign neglect. C. requires heavy use of nitrogen rich composts and mulches. D. may be best suited to blueberries.

Trades & Technology