What should be worn to protect your hands from caustic chemical burns?
A. heavy work gloves
B. ace wraps
C. approved rubber gloves
D. silicone protection spray
Answer: C
You might also like to view...
____ as an engineering design tool began in the 1980s.
A. Computer-based 3-D modeling B. Vector analysis C. Computer-aided drawing (CAD) D. Autodesk
The current in an inductive circuit _____.
a. is faster than the voltage b. is the same as the voltage c. lags the voltage d. counteracts the voltage
When installing a tire pressure monitoring system sensor on a wheel, the sensor should be mounted ____________
A) With the flat part of the sensor facing the center section of the rim B) With the flat part of the sensor parallel to the center section of the rim C) Both A and B D) Neither A nor B
Two technicians are discussing rear shock absorbers. Technician A says that if one shock is leaking, then both rear shock absorbers should be replaced. Technician B says that the rear axle should be supported before removing the rear shock absorbers. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians A and B D) Neither technician A nor B