When maximum clearance is achieved in a clearance fit, the shaft will be at its ____ size.
A. maximum
B. average
C. minimum
D. transition
Answer: C
You might also like to view...
All of the following statements are true EXCEPT:
A. machinists use a pin press to separate pressed-fit pins and pistons from their connecting rods. B. pistons have a notch on the side of the piston head that faces the front of the engine. C. always soak a piston and rod assembly in a chemical cleaner. D. reinstallation is done using a rod heater to heat the eye of the rod.
What is the main difference between national scenic trails and national recreational trails?
What will be an ideal response?
The addition of ____ gives FCAW the high level of reliability needed for welding on boilers, pressure vessels, and structural steel.
A. flux B. small diameter electrodes C. slags D. bevels
What size and type of connecting bolts are used for the majority of structural steel connections for commercial buildings?
What will be an ideal response?