In the IRC, where do you find nailing specifications charts for I-joists?

A) Manufacturer instructions B) Local building codes
C) Jobsite supervisor D) IRC


A

Trades & Technology

You might also like to view...

A ____ section is produced when the cutting plane is parallel to the long axis of the structure.

A. partial B. dividing C. full D. longitudinal

Trades & Technology

The current in an inductive circuit _____.

a. is faster than the voltage b. is the same as the voltage c. lags the voltage d. counteracts the voltage

Trades & Technology

The carry output of a half-adder circuit can be expressed as ________.

A) Cout = A ? B B) Cout = AB C) Cout = A + B D) None of these

Trades & Technology

When tapping brass, what cutting fluid is recommended?

A. lard B. soluble oil C. none D. kerosene

Trades & Technology