Outside micrometers are being discussed. Technician A says that on English system micrometers, sleeve markings are in .025 inch increments. Technician B says that on metric system micrometers, sleeve markings are in .005 millimeter increments. Who is correct?
A. A only
B. B only
C. Both A and B
D. Neither A nor B
Answer: A
You might also like to view...
All of the following statements are true EXCEPT:
A. if the starter drive will be reused, you should immerse it in cleaning solvent. B. whenever a starter is apart, new brushes should be installed. C. some starter brushes are soldered in place, and others can be installed with screws. D. starter brushes occasionally wear too thin and have to be replaced.
The color coding in solid-color, non-twisted pair quad wire is red, green, ____________________, and ____________________.
Fill in the blank(s) with the appropriate word(s).
In the above figure, when the physical load increases and causes the armature to slow down, the CEMF decreases, which causes the voltage at the junction between R8 and R9 to ____________________ (increase, decrease), the output of the op amp 1 goes more ____________________ (negative, positive), which causes the output of the summing amp to go more ____________________ (negative, positive) and causes the motor speed to rise.
Fill in the blank(s) with the appropriate word(s).
?Most panel radiators have a high thermal mass.
Answer the following statement true (T) or false (F)