Hardware and hardware finish are often included in a(n) _____.

a. finish listing
b. hardware schedule
c. accessory table
d. door schedule


Answer: D

Trades & Technology

You might also like to view...

Six measurements are taken of the thickness of a piece of 18-gauge sheet metal. The measurements (in mm) are: 1.316, 1.308, 1.321, 1.303, 1.311, and1.310.

a. Make a dotplot of the six values. b. Should the t curve be used to find a 99% confidence interval for the thickness? If so, find the confidence interval. If not, explain why not. c. Six independent measurements are taken of the thickness of another piece of sheet metal. The measurements this time are: 1.317, 1.318, 1.301, 1.307, 1.374, 1.323. Make a dotplot of these values. d. Should the t curve be used to find a 95% confidence interval for the thickness of this metal? If so, find the confidence interval. If not, explain why not.

Trades & Technology

A bicycle and rider have a total weight of 210 pounds. To minimize road friction, each tire should not contact more than 1.5 in^2 of the road surface. How much pressure should each tire contain?

What will be an ideal response?

Trades & Technology

A resume should be how many pages long?

A) 1 B) 2 C) 3 D) 4 or more

Trades & Technology

Which of the following statements is correct?

A) The number of ladder logic virtual relays and input and output instructions is limited only by memory size. B) The number of contacts for a mechanical relay is limited to number of coils on the relay. C) A ladder logic program is hard to analyze because it is totally different when compared with the equivalent relay logic solution. D) Ladder logic is a PLC graphical programming technique introduced in the last 10 years.

Trades & Technology