?The most efficient method to draw teeth is to:

A. use a gear tooth caliper
B. draw one tooth then trace the rest
C. use a gear template
D. All of the above can be used.


Answer: C

Trades & Technology

You might also like to view...

While checking a ring gear contact pattern it is noticed that the pattern moves from the middle towards the toe of the ring gear, once per revolution. Technician A says that is indicates ring rear runout. Technician B says that the pinion gear has runout. Which technician is correct?

A) Technician A only B) Technician B only C) Both technicians D) Neither technician

Trades & Technology

Bend allowance the amount of extra material needed for a bend to compensate for compression during the bending process.

Answer the following statement true (T) or false (F)

Trades & Technology

Which IC counters would best be used to configure a divide-by-80 counter?

A) 7490 and 7493 B) 7493 and 7492 C) two 7492 ICs D) 7490 and 7492

Trades & Technology

Figure 10-1 The type of sensing device in Figure 10-1 is a(n) ____.

A. orifice plate B. paddle wheel C. Hall-effect detector

Trades & Technology