When testing an ECT sensor on a vehicle, a digital multimeter can be used and the signal wire tested with the connector attached with the ignition on (engine off). What setting should the technician use to test the sensor?
A) Hz (hertz)
B) Ohms
C) DC volts
D) AC volts
C
Trades & Technology
You might also like to view...
In order to prime a typical fuel sub-system with a hand-primer pump that has to be installed into the circuit, where should it ideally be located?
A. close to the pick-up tube B. upstream from the primary filter C. upstream from the transfer pump D. downstream from the secondary filter
Trades & Technology
There is no way to reliably predict shrinkage in welds
Indicate whether the statement is true or false
Trades & Technology
What is the formula for calculating torque?
What will be an ideal response?
Trades & Technology
Oil normally thins out when heated.
Answer the following statement true (T) or false (F)
Trades & Technology