Al ensamblar secciones de una pluma reticulada, los colgantes deben estar _____.

a. en frente de las secciones que se conectarán
b. detrás de las secciones de la pluma que se conectarán
c. en el suelo directamente debajo de la pluma
d. acoplados al mástil hasta que se hayan conectado todas las secciones de la pluma


b. detrás de las secciones de la pluma que se conectarán

Trades & Technology

You might also like to view...

?A rapid-setting acrylic adhesive that polymerizes when pressure is applied to the joint is ____. 

A. ?polyvinyl alcohol  B. ?N,N-dimethylformamide C. ?cyanoacrylate D. ?polyvinyl butyral

Trades & Technology

In the final finish grinding on a hardened workpiece, the traverse rate should be reduced to about how much of a grinding wheel width per workpiece revolution?

A) Three-fourths B) One-eighth C) One-half D) One-fourth

Trades & Technology

When the SPL values of two noise sources differ by more than -dB, the weaker noise source will not be noticeable due to -masking.¬

a. 3 b. 10 c. 15 d. 20 e. 25

Trades & Technology

The construction of the demos in places such as Athens paralleled the emergence of what?

a. the agora as the center of life in all poleis b. the growth of the population above 1,500 citizens c. the removal of tyrants from power in most poleis d. the emergence of the phalanx as the basic fighting unit of most poleis

Trades & Technology