Answer the following statement(s) true (T) or false (F)
1. In the circuit shown in the accompanying figure, the current sensor contacts are normally open.
2. Resistors connected in series with the motor limit the amount of in-rush current.
3. One way of determining when to shunt the resistors out of the circuit is by sensing motor current.
4. In an inductive circuit, the current must rise at an exponential rate.
5. In a resistive circuit, the current will take some time to reach its full Ohm’s law value.
1. False
2. True
3. True
4. True
5. False
You might also like to view...
A(n) ____________________ has small wheels and saves wear and tear on a body when working in uncomfortable positions or working under a car that is resting on vehicle support stands.
Fill in the blank(s) with the appropriate word(s).
What could be the problem if a noid light remains on (does not flash) with the engine cranking?
A) Short to ground in the injector ground circuit, or defective PCM B) Blown injector fuse C) High injector resistance D) Low system voltage
What do R-values measure?
A) heat flow resistance B) CO2 levels C) solar energy D) All of the above
If the transmission ratio is 1:1, the driveshaft speed is equal to engine speed
Indicate whether the statement is true or false