The convention is to show ____ in multiview drawings when working with auxiliary views; this is in contrast with the standard practice, where they are not usually shown.

A. fold lines
B. related views
C. adjacent views
D. measurements


Answer: A

Trades & Technology

You might also like to view...

The vent located at the left rear of the vehicle is used to ________

A) Cool the high voltage battery pack B) Cool the vehicle system controller (VSC) C) Provide cool air for the gasoline engine D) Both A and B

Trades & Technology

What is the maximum safe amount of refrigerant for a recovery cylinder with a water capacity of 50 pounds, holding a refrigerant with a specific gravity of 0. 9?

A) 50 lbs × 0. 8 = 40 lbs B) 50 pounds C) 50 lbs × 0. 8 × 0. 9 = 36 pounds D) 50 lbs × 0. 9 = 45 lbs

Trades & Technology

This is considered a theoretically exact size, location, profile, or orientation of a feature or point.

A. actual size B. basic dimension C. true dimension D. none of the above

Trades & Technology

Which component allows vertical movement of a structure without creating additional load stress?

a. X-bracing b. King stud c. Cripple stud d. Slip connector

Trades & Technology