The logic gates required to implement the logic circuit in the preceding question would be:
A) an Exclusive OR gate with inputs B1 and B2 whose output is fed, along with input A, to an OR gate.
B) an Exclusive NOR gate with inputs B1 and B2 whose output is fed, along with input A, to an OR gate.
C) an Exclusive NOR gate with inputs B1 and B2 whose output is fed, along with input A, to an AND gate.
D) an Exclusive OR gate with inputs B1 and B2 whose output, is fed along with input A, to an AND gate.
D
You might also like to view...
The ____ pass is used to fill the groove with weld metal.
A. root B. filler C. cover D. guard
A hybrid vehicle 12 volt battery is located under the hood. This will usually be a ________ type battery
A) NiCad B) AGM design C) Gel-cell D) Flooded
Which of the following flip-flop timing parameters indicates the time it takes a Q output to respond to an input?
A) tw(1), tw(h) B) fmax C) tphl, tplh D) ts, th
A good way to fasten insulation to the inside of sheet metal duct is to use ____.
A. "S" fasteners (clips) and drive clips (cleats) B. staples and tape C. self-tapping screws and draw bands D. tabs and adhesives