?The company Moldflow® is prominent in the field of ____.
A. ?rapid prototyping
B. ?computer-aided flow analysis
C. ?computer-aided design
D. ?computer-aided engineering
Answer: B
You might also like to view...
What is the difference between jogging and inching?
What will be an ideal response?
A fiber-spinning process currently produces a fiber whose strength is normally distributed with a mean of 75 N/
. The minimum acceptable strength is 65 N/.
a. Ten percent of the fiber produced by the current method fails to meet the minimum specification. What is the standard deviation of fiber strengths in the current process?
b. If the mean remains at 75 N/
, what must the standard deviation be so that only 1% of the fiber will fail to meet the specification?
c. If the standard deviation is 5 N/, to what value must the mean be set so that only 1% of the fiber will fail to meet the specification?
MAF sensor electrical connectors should be checked for all of these, EXCEPT ________
A) Corrosion B) Frayed wiring C) Over-tight connectors D) Terminals bent or pushed out of the plastic connector
Technician A says that most TSBs involve a specific stored DTC. Technician B says that the ECT and IAT reading should be close to the same temperature after the vehicle sits for several hours. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians D) Neither technician