The knot shown in the figure above is a _____
a. clove hitch
b. half-hitch safety
c. square
d. bowline
d
You might also like to view...
Table 22-1 shows that steel tooling materials are feasible for ____. ?
A. ?prototype runs B. ?> 1000 number of parts C. ?10-100 number of parts D. ?temporary runs
Technician A says that some crankcase vent systems use a calibrated orifice instead of a PCV valve Technician B says that turbocharged engines often use an oil/water separator in the PCV system. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians D) Neither technician
Full-face gaskets are used for _____
a. components that require a gasket in a unique shape b. raised-face flanges c. full-face flanges d. low-pressure applications only
It is legal to take a stock plan, make minor changes, and pass it off as your design.
Answer the following statement true (T) or false (F)