All of the below are causes of thrust bearing failure, EXCEPT _____.
A. missing or poor electrical grounds
B. excessive torque convertor pressure
C. poor thrust bearing surface finish
D. a correctly installed rope seal
Answer: D
You might also like to view...
Should an incident begin to escalate, the CSIRT team leader continues to add resources and skill sets as necessary to attempt to contain and terminate the incident. The resulting team is called the ____ for this particular incident.
A. IR unit B. reaction force C. forensic team D. response unit
The dead-load supports for each stone slab (in a stone -clad wall) are generally _________.
A) two, placed at the same level at quarter points. B) three, placed at the same level at one-third points. C) two, placed in the center of the slab, one above the other. D) four, placed at the same level at quarter points. E) two, placed at the same level at one-third points.
Two bulbs are connected to a 12 volt battery in parallel. Another bulb is added in parallel. Technician A says that the third bulb will be dimmer than the other two bulbs due to reduced current flow through the filament of the bulb. Technician B says that the amount of current flowing from the battery will decrease due to the extra load. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians D) Neither technician
If the waterflow is reduced, the temperature difference across a condenser will ____.
A. increase B. decrease C. remain the same D. correspond to the evaporator saturation temperature