Technician A says the setup shown in the following figure is being used to check drum internal diameter. Technician B says the setup shown in the following figure is being used to check for an out-of-round drum. Who is correct?

A. A only
B. B only
C. Both A and B
D. Neither A nor B


Answer: C

Trades & Technology

You might also like to view...

Sam estimates that he has 8.6 × 105 corn plants on 44 acres.

a. How many plants does he have per acre? b. He planted 22,500 kernels per acre. What was the percent of germination of the corn?

Trades & Technology

What type of load study is recommended for duct design?

A) A monolithic load study B) A unified load study C) A room-by-room load study D) A shell load study

Trades & Technology

The most common type of defect during printed circuit board assembly is ____.

A. open circuits B. short circuits C. missing parts D. misoriented parts

Trades & Technology

At inventory time, 435 pounds of magnet wire for winding motors is available. In ten successive days, 15 pounds, 6 pounds, 24 pounds, 12 pounds, 3 pounds, 8 pounds, 17 pounds, 32 pounds, 16 pounds, and 13 pounds of wire are taken out of stock. How many pounds are left?

Fill in the blank(s) with the appropriate word(s).

Trades & Technology