Technician A says that a PTO driveshaft should be made of a solid steel bar when the auxiliary it drives has to be driven at a speed greater than 1200 rpm. Technician B says that solid PTO driveshafts can be made from round section, square section, and hex section steel stock. Who is correct?
A. Technician A only
B. Technician B only
C. Both A and B
D. Neither A nor B
Answer: B
Trades & Technology
You might also like to view...
Copper wire bends easily, has good mechanical strength, resists corrosion, and can be easily joined.
Answer the following statement true (T) or false (F)
Trades & Technology
The largest segment of the meat industry is _____
A) beef B) pork C) lamb D) mutton
Trades & Technology
Why are organic fertilizers not widely used on turfgrass?
a. too expensive c. not readily available b. too low in nitrogen d. not environmentally responsible
Trades & Technology
A linear component is one in which an increase in current is proportional to the applied voltage as given by Ohm's law. Which of the following is an example of a linear component?
A) Capacitor B) Diode C) Resistor D) Transistor
Trades & Technology