Where is the liquid receiver located?
A) On the low side just before the compressor B) On the low side just after the metering device
C) On the high side just after the compressor D) On the high side just after the condenser
D
You might also like to view...
Answer the following statement(s) true (T) or false (F)
1. The most standardized set of symbols in the United States is provided by the NEMA. 2. Normally open switches are drawn with the movable contact above and touching the stationary contact. 3. Schematics are always drawn to show components in their de-energized or off state. 4. The most common coil symbol used in schematic diagrams is the rectangle. 5. Timed contacts are either normally open or normally closed.
The term ____ refers to the process of cooling the circulating condenser water by evaporating the tower water.
A. cyclic B. adiabatic C. isothermal D. polytropic
Technician A changes the position of a waste-spark ignition coil to diagnose an ignition misfire. Technician B says that a defective coil should cause problems on the cylinders it is connected to. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians D) Neither technician
A shipment of 15 heat pumps arrives for storage at an electrical supply house. The pumps cannot be stacked, and each has a base measurement of 3.2 feet by 3.8 feet. A storage area 14 feet long and 12 feet wide is available. Is there sufficient space to store the shipment?
A. Yes B. No