What is a typical pinion bearing preload, when measured with a torque wrench on the pinion nut?
A) 17?22 Foot-Pounds
B) 17?22 Inch-Pounds
C) 120?150 Foot-Pounds
D) 50?75 Inch-Pounds
B) 17?22 Inch-Pounds
You might also like to view...
A wiring diagram showing in detail the electrical components and circuitry is known as a ____.
a. schematic b. blueprint c. block diagram d. service detail
Solve and reduce all answers to lowest terms:3 1/8 - 1/4 =
What will be an ideal response?
If the resistance of the run winding decreases, the ____.
A. motor probably will not start B. motor will draw too much current while it is running C. centrifugal starting switch will not start the motor D. load on the motor is probably too great
Answer the following statement(s) true (T) or false (F)
1. An impedance (distance) relay on a particular line may also act as a backup for a relay on another line. True or false?
2. A balanced three phase fault is the most common type of transmission line fault. True or false?
3. A wind turbine with just an induction generator (a Type 1 design) is usually modeled in the power flow as a PV bus. True or false?
4. For the general minimization problem minx f(x) s. t. g(x)=0 , we define the Lagrangian as
, then
is just a restatement of .g(x) = 0.