Technician A says oil flow calibration in a shock absorber or strut must be in relation to the deflection rate of the spring. Technician B says oil flow calibration in a shock absorber or strut must be in relation to the length of the lower control arm. Who is correct?
A. A only
B. B only
C. Both A and B
D. Neither A nor B
Answer: A
You might also like to view...
Why are eleven pin control relays used to provide interlock protection?
What will be an ideal response?
The presidential elections of the 1870s and 1880s
A. were all won by Republicans. B. revolved primarily around the charismatic personalities running for the presidency. C. were all won by Democrats. D. usually involved sharp partisan differences over issues like currency policy and civil-service reform. E. aroused enormous turnouts among voters even though there were few significant issues.
Which of the following factors affect the coefficient of friction in a brake system?
A. The surface finish of both friction surfaces B. The metal of the rotors and drums and the friction material of the pads and linings C. Temperature D. All of the above
The difference between vent sizing for natural draft appliances and fan assisted appliances is that
A) Columns for fan assisted appliances list sizes for both vertical and horizontal installation B) Columns for fan assisted appliances list both a minimum and a maximum appliance capacity for each vent size C) Vents for fan assisted appliances are typically larger in diameter for the same BTU capacity D) Vents for fan assisted appliances are always the same size as the connector on the furnace