While discussing drill bits, Technician A says that a drill bit that is sharpened "off center" will drill a hole that is too small. Technician B says that it will drill a hole that is too large. Who is correct?
A. A only
B. B only
C. Both A and B
D. Neither A nor B
Answer: B
Trades & Technology
You might also like to view...
The ____ of a motor is the amount of torque developed at the instant the motor is energized.
A. starting torque B. opening torque C. initial torque D. rated load torque
Trades & Technology
If the positional tolerance of the hole in problem 2 above is zero at MMC, then what would the positional tolerance be at the actual produced sizes given below?
Trades & Technology
Sometimes the green construction definition sounds complicated.
Answer the following statement true (T) or false (F)
Trades & Technology
If the C-shaped tube of a Bourdon gauge becomes more straight, the pressure that it is reading has __________.
A. increased B. decreased
Trades & Technology