A five-speed manual transaxle is noisy in all gears. Which is the least likely cause?
A. Final drive side (differential) bearings
B. An output shaft bearing
C. A pilot bearing
D. An input shaft bearing
Answer: C. A pilot bearing
You might also like to view...
Technician A says that EHI pressure at the beginning of an injection pulse should be closely equivalent to rail pressure. Technician B says that EHI pressure at the end of an injection pulse will have dropped off significantly. Who is correct?
A. Technician A only B. Technician B only C. Both A and B D. Neither A nor B
Which of the following industrial processing methods is currently used to yield hydrogen from water?
A. distillation B. cold temperature fractioning C. electrolysis D. catalytic cracking
How much heat is required to increase the temperature of 20 lb of water from 32°F to 212°F?
A) (20 × 144 ) + (20 × 180 ) + (20 × 970 ) = 25,880 BTU B) 212°F - 32°F = 180 BTU C) 20 lb × 180°F = 3,600 BTU D) 20 lb × 0.5 × 180°F = 1,800 BTU
When changing a low-voltage transformer, the service technician should:
A) Use a replacement transformer with a higher VA rating to make it last longer. B) Check all low-voltage controls for shorts and grounds. C) Use a replacement transformer with a higher-voltage primary winding to make it last longer. D) Temporarily short across the secondary side of the transformer to test its output.