How are section lines commonly treated when sectioning?
What will be an ideal response?
Very thin parts in
sections can be shown without section lines. While the ASME Y14.3 standard
covering sectioning applications recommends omitting section lines in thin
sections, some companies prefer the practice of using solid fill on very thin
sections.
You might also like to view...
?In____, air pressures of over 2.7 MPa may be used to blow a hot plastics sheet through the silhouette of a female mold.
A. ?snap-back forming B. ?twin sheet thermoforming C. ?free forming D. ?mechanical forming
A typical evaporator temperature of a walk-in at a -10° box temperature is:
a. -30° b. -20° c. -10° d. 0°
If the construction drawings do not include a reflected ceiling plan, you should _____
a. read the specifications b. report the situation to your supervisor c. see if a shop drawing is included d. draw your own plan
If a diode shorts in a full-wave rectifier, ________
A) the output dc voltage will increase B) no change would occur in the output C) the output current would increase D) the output dc voltage will decrease and possibly damage the power supply