Answer the following statement(s) true (T) or false (F)
1. The input/output section, or I/O section, is the major reason that PLCs are so versatile when used with process machines or driven equipment.
2. Discrete I/O modules are types of modules that only accept digital or ON- and OFF-type signals.
3. Status lights are provided for each output point to indicate when that point has been turned OFF.
4. The analog output module changes Binary or BCD values generated in the PLC logic into analog signals using an RTD.
5. While it is important that the controller and programming unit be installed or mounted in a control center or other central location, the use of remote I/O racks allows the input and output modules to be installed close to the actual operating equipment.
1. True
2. True
3. False
4. False
5. True
You might also like to view...
A low-head hydro penstock is 215 ft. 6 in. long. What is this length in cm??
Fill in the blank(s) with the appropriate word(s).
Remove the ignition wire from the ______________________________ before touching a rotary blade
Fill in the blank(s) with correct word
A 12-volt test light is touched into a connector. The light goes on. Following the conductor forward (toward the load), the next connector is probed with no light. What does this indicate?
A. Nothing is wrong B. An open load C. An open before the first connector D. An open circuit between the two points
An oil pressure warning lamp is usually controlled by which of these devices?
A) Ground sensor B) Voltage drop C) Sensor unit D) Manual switch