The profile tolerance can be between two given points of the object. This specification is shown by using the between symbol under the feature control frame. Any combination of letters can be used, such as A and B or C and D, or X and Y. The true profile is established by a basic or tolerance dimension.
Answer the following statement true (T) or false (F)
True
Trades & Technology
You might also like to view...
A very common problem with transmission line communications involves what type of failure between communications terminals?
A. Capacitor B. Antenna C. Cable D. Voltage
Trades & Technology
Explain what you would check on a meter if you did not get a reading when you tried to zero the meter
What will be an ideal response?
Trades & Technology
Because self-closing compression faucets have a tendency to receive too little water flow, one problem that can
occur with them is that _____. a. lubrication can be required to unstick the faucet b. the valve can work its way loose c. the supply line can dry out d. lime and other minerals can build up in the system
Trades & Technology
What is phase paper?
What will be an ideal response?
Trades & Technology