____ specifies the larger positional tolerance for the pattern of features as a group.
A. The feature relating control
B. The pattern locating control
C. The positional relating control
D. The group locating control
E. none of the above
Answer: B
You might also like to view...
Which of the following terms is used to describe those people or organizations that have a specific vested interest in the success or failure of some event, action, or organization?
A) Stakeholders B) Core competencies C) Strengths/Weaknesses/Opportunities/Threats Analysis D) Environmental scan
A loud "bang" is heard and felt every time the accelerator is depressed or released on a rear-wheel drive vehicle. Technician A says that a leaking shock absorber could be the cause. Technician B says that a broken torque arm could be the cause. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians D) Neither technician
Which of the following suspension systems will NOT usually be used as a front axle, truck suspension?
A. equalizing-beam B. camelback C. solid rubber block D. all of the above
Which of the following methods are used to access diagnostic codes from a controller with an address on a truck data bus?
A. flash codes B. PC-based EST C. generic HH-EST D. All of the above