Incoming cool water enters the end of a water cooled condenser where ______________.
a. hot gas is entering the condenser
b. liquid refrigerant is leaving the condenser.
c. the hot water is leaving the condenser.
d. the compressor is located.
b. liquid refrigerant is leaving the condenser.
You might also like to view...
Referring to the figure shown below, technician A says that a short to ground between Sw 2 and the associated body controller input terminal would cause intermittent wiper action with the wiper switch in the Low or High position. Technician B says that a short to ground between Sw 1 and the associated body controller input terminal would cause intermittent wiper action with the wiper switch in the OFF position. Who is correct?
A. A only B. B only C. Both A and B D. Neither A nor B
The discharge air temperature is warm or slightly cool. The pressure gauges shown indicate which MOST LIKELY cause?
A) Excess refrigerant in the system B) Lack of airflow through the condenser C) Low on refrigerant D) Defective compressor
Two soil samples, A and B, at different soil moisture levels are placed in contact with each other. Water will more likely move from soil A to soil B if their water potentials, expressed in kPa, are ________
A) A=-30; B=-40 B) A=-5; B=-5 C) A=-20; B=-10 D) A=-5; B=+5 E) A=-100; B=-50
The required width of the stem wall varies depending on the soil loads, height of the wall, and the material used.
Answer the following statement true (T) or false (F)