When using a belt tension gauge, the proper tension setting can be obtained from which source?
a. The equipment manufacturer
b. The pulley manufacturer
c. The unit data plate
d. The Rubber Manufacturer’s Association (RMA)
a. The equipment manufacturer
You might also like to view...
Cabin filters can be replaced and are located by an access panel ________.
A) Under the hood B) Under the dash (usually behind the glove box) C) Under the vehicle D) Either A or B
When mixing oxygen and fuel gas, one method uses a higher oxygen pressure and mixes gases in a(n) ____.
A. mixing chamber B. injector chamber C. fuel injector D. injector mixer
A standard series soil test may include all of the following EXCEPT ____
a. texture b. organic matter c. pH d. available phosphorous e. nitrogen f. exchangeable potassium
What should be done if a furnace with a tripped primary control has oil is in the combustion chamber?
A) Clean out the oil before firing the furnace. B) Push the reset button and let the fire burn off the excess oil. C) Disconnect the vent connector before firing the furnace to avoid soot accumulation in the vent. D) Burn off the excess oil using a propane torch before firing the furnace.