Legal descriptions are word pictures that describe parcels of land. The three most widely used types are ____.
A. compass bearings, subdivisions and plats, and rectangular system
B. metes and bounds, subdivisions and plats, and township grids
C. compass bearings, lot and block, and township grids
D. metes and bounds, lot and block, and rectangular system
Answer: D
You might also like to view...
The circuit shown in Figure 2 is a(n) _____.
a. autotransformer reduced-voltage starter
b. part winding reduced-voltage starter
c. wye-delta reduced-voltage starter
d. solid-state reduced-voltage starter
A term used to describe flow in a heat exchanger where tube-side flow and shell-side flow go in opposite directions.
a. cross flow b. horizontal flow c. parallel flow d. counter flow
Dogs can be trained to respond to ____________________ language commands
Fill in the blank(s) with correct word
A single crystal of copper yields under a shear stress of about 0.62 MPa. The shear modulus of copper is approximately 7.9 x 10 psi. With this data, compute an approximate value for the ratio of the theoretical to the experimental shear stresses in copper.
What will be an ideal response?