The basic approach to testing D/A converters is to ________
A) single-step the device through its full input range while checking the output with a DMM
B) check the output with zero input and then full input. The output of the converter should extend from zero to its maximum value. If so, then everything in between can be assumed to be operating properly
C) apply the correct input to the analog terminal and then check to see if the proper binary code exists on the digital inputs
D) apply a sequence of binary codes covering the full range of the input to the input while observing the output on an oscilloscope. The output should consist of a linear stairstep ramp
D
You might also like to view...
Asbestos is no longer used in the USA.
Answer the following statement true (T) or false (F)
Answer the following statement(s) true (T) or false (F)
1. The number of accelerating contactors depends on the desired number of speeds for the motor. 2. The motor starts slowly with full resistance in the primary circuit. 3. The speed may be changed from medium to low or high to low by pressing the medium-speed push button. 4. The resistors should have a high enough power rating to operate at any speed.
A diesel engine produces pronounced combustion knock along with white smoke emission. Which of the following is the more likely cause?
A. High sulfur fuel. B. Advanced fuel injection timing. C. Out of balance fuel injection system. D. Air leak in suction side of the fuel subsytem system.
List three common techniques used to strip paint from metal surfaces.
What will be an ideal response?