The two most common categories of gas-fired furnaces are:

A) Category III and Category IV. B) Category I and Category IV.
C) Category I and Category II. D) Category II and Category III.


B

Trades & Technology

You might also like to view...

?What tip material is resistant to oxidation at high temperatures?

A. ?tungsten B. ?hafnium C. ?copper D. ?brass

Trades & Technology

Determine the number of 4-foot-wide by 8-foot-high sheets of drywall needed for the tenant finish in Figure 16.16. The walls are 8 feet high. The exterior walls need drywall on the interior side only. The interior walls need drywall on both sides. Add 5 percent waste.

What will be an ideal response?

Trades & Technology

Which of the following was part of the URAA?

a. Members were required to convert non tariff barriers to tariffs of TRQs. b. Members were required to reduce trade distorting subsidies 20% over 5 years. c. Export subsidies were required to be reduced. d. Sanitary and phytosanitary regulations were required to be science based. e. All of the above.

Trades & Technology

Give several reasons for the development and use of plastics

What will be an ideal response?

Trades & Technology