Where should voltmeter test leads be placed to check for voltage drop?
A. Across the component or connection being tested.
B. From the positive side of the component to the battery negative post.
C. In series with the component being tested.
D. From the positive side of the component to chassis ground.
Answer: A
You might also like to view...
Answer the following statement(s) true (T) or false (F)
1. It is common to deal with circuits that are either pure series circuits or pure parallel circuits. 2. There is no one formula that can be applied to an entire circuit to obtain the desired answer or answers. 3. Ohm’s law must be applied first to one part of the circuit and then to another part to obtain a desired answer. 4. Kirchhoff’s voltage law states that around any closed loop, the algebraic sum of the voltages is equal to zero. 5. A junction of three wires is called a node.
Match each 1948 presidential candidate below with his political party. A. J. Strom Thurmond 1. Progressive B. Henry Wallace 2. Democratic C. Harry S Truman 3. States' Rights D. Thomas E. Dewey 4. Republican
A. A-1, B-3, C-2, D-4 B. A-4, B-2, C-1, D-3 C. A-3, B-1, C-2, D-4 D. A-1, B-4, C-3, D-2 E. A-2, B-3, C-4, D-1
The ____ Emacs command is used to move the cursor to the beginning of the file.
A. Alt+< B. Ctrl+< C. Alt+b D. Ctrl+b
In fully automatic transmissions, all gear changes are controlled by:
A. the clutch and gear levers B. computers or hydraulics C. foot pedals D. range selector levers