When used in control cable, which of the following must be grounded in order to be effective?
a. Drain wires
b. Crimp connectors
c. Conductors
d. Screw terminals
b. Crimp connectors
You might also like to view...
The burner gas input rate can be varied in 1 percent increments by using _____.
a. an automatic gas valve b. a variable-speed inducer fan c. LP gas d. a modulating gas valve
A towel and water or rubbing alcohol should be used to clean the heifer's:
A. eyes B. hooves C. nose D. ears
Which symbol is used to identify edge-triggered flip-flops?
A) The letter E on the Enable input. B) A bubble on the Clock input. C) An inverted "L" on the output. D) A triangle on the Clock input.
A sheave should be placed:
A. As close to the bearing as possible. B. Midway between the bearing and the end of the shaft. C. As far away from the bearing as possible. D. None of the above answers is correct.