The proper resistor can be selected by knowing the required resistance and the power value in ____.
a. ohms
b. watts
c. amperes
d. hertz
b. watts
You might also like to view...
Capacitor-start capacitor-run motors that are not hermetically sealed contain a centrifugal switch to disconnect the start capacitor when the motor reaches about ____% of its full load speed.
a. 25 b. 50 c. 75 d. 90
What is the minimum amount of dissolved oxygen needed for good health, growth and
reproduction of fish? A. 16 ppm B. 12 ppm C. 8 ppm D. 4 ppm.
Value engineering can best be described as ____________
a. Reducing cost by reducing quality b. Getting the best value for the least cost c. Reducing scope to achieve budget d. Reorganizing the project team to achieve the greatest efficiency e. None of the above
If a gear shift lever on a COE truck chassis jams in gear, which of the following would be the most likely cause?
A. improper linkage adjustment B. broken detent spring C. clutch brake drive tangs sheared D. worn input shaft bearings