Warpage is being measured on the mating surface cylinder head around the edges and across the center. Technician A says that 0.003" (0.076mm) warpage is generally acceptable. Technician B says that if the warpage is excessive, the engine was most likely overheated. Who is correct?
A. A only
B. B only
C. Both A and B
D. Neither A nor B
Answer: C
Trades & Technology
You might also like to view...
Funds used to pay bills are called _____
A) working capital B) loans C) ?initial funding D) fixed assets
Trades & Technology
Use nodal analysis and MATLAB to find V? in the circuit in Fig. 3.73.
 FIGURE 1.png)
Trades & Technology
Name the vertical distance measured from the tread nosing to a wall or floor above the stairs.
What will be an ideal response?
Trades & Technology
Solve the following problem and if necessary round answer to two decimal place: 
.
What will be an ideal response?
Trades & Technology