If the size of the wheel cylinder is increased during honing by less than 0.005", the cylinder must be replaced.
Answer the following statement true (T) or false (F)
False
You might also like to view...
Most dishwashers have a(n) ____ as an internal backflow device to protect the potable water supply.
a. air gap b. reduced pressure zone backflow preventer c. pressure-type vacuum breaker d. high loop vacuum breaker
Which of the following methods is allowed for installing lagging sub-girts over mineral wool board insulati
a. Use adhesive to attach the sub-girts to the insulation. b. Place pre-drilled sub-girts onto insulation weld pins and secure both with speed clips. c. Wire the sub-girts to insulation pins. d. Stretch stainless steel banding between equipment ribs to hold the sub-girts in place.
The equalizer line of an externally equalized TXV is best attached _____.
a. downstream of, and near, the sensing bulb b. at the inlet of the evaporator coil c. downstream of any suction line traps d. downstream of any other valves in the suction line
Soldering is done above 450° C and brazing is done below 450° C.
Answer the following statement true (T) or false (F)