Answer the following statement(s) true (T) or false (F)
1. The charge termination set point (CTSP) is the voltage level setting of a charge controller that results in a charging current being supplied to the batteries.
2. Low voltage disconnect (LVD) is the amount of voltage set on a charge controller that when reached causes system loads to be disconnected to prevent battery overdischarging.
3. The series type charge controller uses a sensor (instead of a blocking diode) to prevent reverse current flow at night.
4. The pulse width modulation controller diverts excess charging current to some type of electrical load such as a fan or heater.
5. When a battery has a low state of charge, the charge controller will deliver a large charging current in an effort to charge the battery in a timely manner.
1. FALSE
2. TRUE
3. TRUE
4. FALSE
5. TRUE
You might also like to view...
A protective covering that wraps or protects a cable by a nonconductive covering is called a ____.
a. coat b. sheath c. cover d. case
What factor(s) primarily determine solenoid valve selection?
a. Refrigerant line size b. Flow rate and pressure drop c. Direction of refrigerant flow d. Number of on/off cycles
High school agribusiness and agriscience programs today provide such excellent training for business
that further education in business management may be unnecessary.
Indicate whether the statement is true or false.The preferred tolerance specification method that identifies the maximum and minimum limits
a. General tolerances b. Basic hole system c. Basic shaft system d. Limit dimensioning e. Plus-or-minus dimensioning