Designers use manual precision measurement tools, coordinate measuring machines (CMM), and laser scanners to collect geometry for input into ____ programs.
A. benchmark
B. CAD
C. continuous improvement
D. IP
Answer: B
You might also like to view...
Summarize the results for testing an NPN transistor with a DMM.
What will be an ideal response?
A typical 6 way power seat uses ________
A) 2 electric motors and a 3-way direct acting transmission B) 6-9 separate PM non-grounded electric motors C) 1-3 motors (depending on manufacturer) D) 6 separate grounded electric motors only
The following statements are all correct EXCEPT ________
A) Waste-spark systems use a signal from the PCM once the engine is running. B) Waste-spark systems do not need a timing signal from the PCM when cranking the engine. C) No ignition system uses the PCM to control ignition timing. D) Up-integrated ignition controls use the PCM to control ignition timing.
Combination fittings can be used _____
Fill in the blank(s) with the appropriate word (s).