What information would you expect to find in an engineering drawing?

A. Fabrication details for every structural member in a job
B. Details of miscellaneous metal connectors required
C. Locations of major structural components such as columns, beams, and girders
D. Bills of material listing every item that will be used during fabrication of the products and erection of the final structure


Answer: C

Trades & Technology

You might also like to view...

You should let the air out of hot tires so the pressure goes back to normal

Cdl

Trades & Technology

If a vehicle has an open or standard differential in its drive axle and one wheel has 100% traction while the other is sitting on ice, what happens when the drive shaft turns?

a. the wheel with 100% traction starts to spin b. the wheel sitting on ice turns twice as fast as the crown gear c. the drive shaft turns slower than the crown gear d. the crown gear reverses

Trades & Technology

What could be wrong if the A/C compressor clutch cycles on and off rapidly?

A) Defective A/C compressor B) Defective A/C compressor clutch C) Low refrigerant charge D) Shorted compressor diode

Trades & Technology

Failed compressors never deposit debris into the compressor inlet or discharge lines.

A. True B. False

Trades & Technology