A V groove weld symbol with a "3/8" to the right of the symbol, both of which are under the reference line means ____.
A. the weld depth on the arrow side should be 3/8"
B. the depth that the weld penetrates the surface should be 3/8" on the arrow side
C. the depth that the weld penetrates the surface should be 3/8" on the other side
D. the material that this weld is being placed on is 3/8" thick, and the weld should penetrate the entire separation
E. None of the above. This is an incorrect symbol.
Answer: E
You might also like to view...
Technician A says that the transfer case normally uses the same oil checking procedures as in a manual transmission for a given vehicle. Technician B says that most transfer cases do not include a drain plug. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians D) Neither technician
A rectangular pool is filled with water to a depth of 6' 6". The pool is 16' 6" wide and 32' 0" long. How many hours does it take to completely drain the pool if water is pumped at the rate of 48.5 gallons per minute? Round the answer to the nearest tenth hour.
Fill in the blank(s) with the appropriate word(s).
Design a three-phase heater with suitable symmetric loads using wye-connected pure resistance. Assume that the heater is supplied by a 240-V line voltage and is to produce 27 kW of heat.
What will be an ideal response?
A 90 degree angle is called a __________ angle.
Fill in the blank(s) with the appropriate word(s).