The basic approach to testing D/A converters is to ________
A) apply a sequence of binary codes covering the full range of the input to the input while observing the output on an oscilloscope. The output should consist of a linear stairstep ramp
B) single-step the device through its full input range while checking the output with a DMM
C) apply the correct input to the analog terminal and then check to see if the proper binary code exists on the digital inputs
D) check the output with zero input and then full input. The output of the converter should extend from zero to its maximum value. If so, then everything in between can be assumed to be operating properly
A
You might also like to view...
When distortion must be kept to a minimum, which steel type should be used for hardening?
A) Water hardening B) Low carbon C) Oil hardening D) Air hardening
A flow meter that uses a rotor and a magnetic pick-up coil to count rotor revolutions is known as a __________ meter.
A. Doppler B. Faraday C. turbine D. vortex
In general, the largest diameter pipes in a distribution system are the:
A. branch lines B. primary feeder lines C. secondary feeder lines D. distribution lines
When applying a mating surface constraint, you are forcing the normals of the two surfaces to be ____ to each other.
A. perpendicular B. parallel C. opposite D. equivalent