On a front wheel drive vehicle, how is the hub nut adjusted when being reassembled?
A) Finger tight then loosen to insert the cotter pin
B) Tighten the nut to remove all freeplay and then tighten another 1/4 turn
C) Tighten to a torque of between 150 to 200 lb/ft
D) Tighten the nut using a 1/2 inch drive impact wrench
C) Tighten to a torque of between 150 to 200 lb/ft
You might also like to view...
The bases of DNA include
A) Adenine, guanine, thymine, cytosine B) A, B, C, D C) Extra small, small, medium, large
Identify three factors that contribute to heat burn injuries in the workplace
What will be an ideal response?
The compressor in an existing split system is being replaced. The system has a 35 ft line set. The factory charge for the condensing unit is 80 oz. The installation instructions state that the factory charge assumes a line length of 15 ft and gives the per-ft adjustment as 0.6 oz per foot. How much refrigerant should be added to the system after the system has been evacuated?
A) (35 — 15 ) × 0.6 = 12 oz B) 80 oz + ((35 — 15 ) × 0.6 ) = 92 oz C) 80 oz D) 80 oz + (35 × 0.6 ) = 101 oz
Find a sample size for which the median will always equal one of the values in the sample.
What will be an ideal response?