Tech A says the side bearing pre-load and gear backlash are accomplished by adjustments to the differential side bearings. Tech B says the side bearings are adjusted by changing shim thickness on some rear axle assemblies. Who is correct
A. a only
B. b only
C. Both a and b
D. Neither A nor B
D. Neither A nor B
You might also like to view...
In whip grafting, the cambium, the thin tissue under the bark of the scion, must match the growing area _____
A) at the edge of the root piece on at least one side B) not at all C) completely D) at the edge of the root piece on more than one side
Find the current flow (amperes) in a headlight circuit with 0.9 ohms resistance. The battery voltage is measured at 11.8 volts. Round to the nearest tenth.
A. 12.7 B. 12.8 C. 13.1 D. 13.5
Bulk refrigerant, for the purposes of determining what size container must be purchased by an EPA-certified
technician is considered to be any container size equal to/or over _____. A) 20 pounds B) 30 pounds C) 50 pounds D) 125 pounds
How can the number of devices on an analog addressable circuit and the overall distance requirements from the control panel to the farthest device in the loop be determined?
A. It is determined by the manufacturer B. By using end of line devices C. By calculating the high-speed data requirements D. By calculating the total current in the loop