If the circuit to the relay coil is not energizing the coil, the technician should:

A) Perform random voltage and ohm tests.
B) Use the hopscotching technique to find the fault in the circuit.
C) Check resistance in the circuit.
D) None of the above.


B

Trades & Technology

You might also like to view...

Sandy soils drain at a faster rate than clay soils

Indicate whether the statement is true or false

Trades & Technology

Capacity control of an air dryer is done using a hot gas bypass valve.

Answer the following statement true (T) or false (F)

Trades & Technology

The spacer used on a drive pinion gear is used to properly position the gear so that it can correctly mesh with the ________

A) Ring gear B) Differential pinion gears C) Side gear D) Both B and C

Trades & Technology

In a root pass, the penetration is controlled by using the correct torch travel speed and _____

a. travel angle b. work angle c. amperage d. volta

Trades & Technology