The isometric CAD drawing above must be scaled down by a factor of 4 to make room for additional views. The present height is 2 1/2", width is 10 5/16", and the depth measures 8 3/4". Find the new spatial dimension of the depth in inches.
What will be an ideal response?
2 3/16"
You might also like to view...
Which one of these Saginaw rear axles can be visually identified as a 10.5 inch axle? A) A
A) A only
B) B only
C) Either A or B
D) Neither A nor B
Technician A says that a vibration felt in the seats may be caused by improper rear wheel balance. Technician B says that a vibration felt in the steering wheel may be caused by a worn clutch throwout bearing. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians D) Neither technician
The most common types of single phase compressor motors are:
A) Permanent split capacitor (PSC), capacitor start (CS), capacitor start/capacitor run (CSR), and split phase B) Capacitor run (CR), permanent split capacitor (PSC), and capacitor start (CS), and shaded pole types C) Split phase capacitor (SPC), capacitor start (CS), capacitor start/capacitor run (CSR), and semi-permanent split capacitor (SPSC) D) Split phase capacitor (SPC), semi-permanent split capacitor (SPSC), capacitor start (CS), and shaded pole types
What factor causes intake manifold gaskets on a V-type engine to fail?
A) Fretting B) Relative movement between the intake manifold and the cylinder head C) Coolant damage D) All of the above