Why is the typical rear load-leveling system connected to the ignition circuit?
A) To keep the system active for a given time after the ignition is switched off
B) To keep the compressor from running for an extended period of time
C) To prevent the system from working unless the ignition key is on
D) All of the above
D
You might also like to view...
Which are the correct units for the measurement of inductance?
A. Farads B. Ohms C. Lenz D. Henries
When Caterpillar single actuator MEUIs are energized by the ECM drivers, voltage peaks at:
A. 5 V-DC B. 8 V-DC C. 12 V-DC D. over 100 V-DC
Architectural drafting is a universal graphic language that uses lines, symbols, and notes to describe a structure to be built.
Answer the following statement true (T) or false (F)
Which of the following are used with ammeters to increase their range for current measurement?
A) Current-limiting resistors B) Shunt resistors C) Clips D) Magnets