Moisture in a liquid state must be ____ before it can be removed with a vacuum pump.

A. vaporized
B. condensed
C. cooled
D. solidified


Answer: A

Trades & Technology

You might also like to view...

The ABS warning lamp is illuminated continuously. What could cause this?

A. Open wheel speed sensor circuit B. ABS fail-safe relay has been removed C. Open CAN+ circuit D. All of the above could cause the ABS warning lamp to illuminate depending upon the type of system.

Trades & Technology

If a wire repair, such as that made under the hood or under the vehicle, is exposed to the elements, which type of repair should be used?

A) Rosin-core solder and electrical tape B) Solder and adhesive -lined heat shrink or crimp-and-seal connectors C) Butt connectors D) Wire nuts and electrical tape

Trades & Technology

In cattle and sheep, which animal would likely have the lowest lean-to-fat ratio?

a. Female c. Male b. Juvenile d. Castrated male

Trades & Technology

What electrical operating principle is used by a ‘non-contact' throttle position sensors?

A. thermistor B. potentiometer C. variable capacitance D. Hall-effect

Trades & Technology